Antenna Cable
WARNING: This page is about a different car, the 2009 Mercury Milan, 2009 Lincoln MKZ, and 2009 Ford Fusion. However, it is still accessible from the selected car via links, so may be relevant.
The antenna lead-in cable is connected to the ACM and has an in-line connector (located at the right end of the instrument panel below the glove compartment) to the antenna cable. The antenna cable runs along the passenger side rocker panel within the body main wiring harness, and runs up the passenger side C-pillar to the antenna module (MKZ) or to the antenna (Fusion, Milan).
The antenna and lead-in cables are not removable from the wiring harnesses. If either antenna cable needs to be replaced, cut the ends and leave the cable in the wiring harness. Route the new cable on top of the wiring harness and secure it with wire ties. Do not cut into the wiring harness to remove the existing antenna cable.