LEMON Manuals: Even more car manuals for everyone
Home >> Mercury >> 2008 >> Milan Base, 2.3 Z, Automatic >> Repair and Diagnosis >> External Pages >> Different car >> Section 1387 (Electronic Engine Control - 3.0L (4V)) >> Removal And Installation >> Knock Sensor (KS) >> Removal And Installation

Removal And Installation

WARNING: This page is about a different car, the 2009 Mercury Milan and 2009 Ford Fusion. However, it is still accessible from the selected car via links, so may be relevant.
  1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to JACKING AND LIFTING article.
  2. Disconnect the Knock Sensor (KS) electrical connector.
  3. Remove the bolt and the KS.
    • To install, tighten to 20 Nm (177 lb-in).
  4. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals