LEMON Manuals: Even more car manuals for everyone
Home >> Mercury >> 2008 >> Milan Base, 2.3 Z, Automatic >> Repair and Diagnosis >> External Pages >> Different car >> Section 1382 (Anti-Lock Brake System - Vehicle Dynamic Systems) >> Removal And Installation >> Wheel Speed Sensor - Rear, All Wheel Drive (AWD) >> Removal And Installation

Removal And Installation

WARNING: This page is about a different car, the 2009 Mercury Milan, 2009 Lincoln MKZ, and 2009 Ford Fusion. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the rear seat bolster. For additional information, refer to SEATING .
  2. Disconnect the wheel speed sensor electrical connector.
  3. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to JACKING AND LIFTING .
  4. Using a suitable tool, disconnect the grommet from the body.
  5. Remove the wheel speed sensor harness nut and bolt.
    • To install, tighten to 23 Nm (17 lb-ft).
  6. Remove the wheel speed sensor wire bolt and the wheel speed sensor.
    • To install, tighten to 23 Nm (17 lb-ft).
  7. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals