Removal And Installation

WARNING: This page is about a different car, the 2009 Mercury Milan, 2009 Lincoln MKZ, and 2009 Ford Fusion. However, it is still accessible from the selected car via links, so may be relevant.

With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to JACKING AND LIFTING article.
Remove the retainers and position the fender splash shield aside.
Disconnect the wheel speed sensor electrical connector.
Remove the 2 wheel speed sensor harness bracket bolts.
- To install:
  - Tighten the bracket-to-wheel knuckle bolt to 23 Nm (17 lb-ft).
  - Tighten the bracket-to-body bolt to 7 Nm (62 lb-in).
Remove the front wheel speed sensor bolt from the knuckle and remove the wheel speed sensor.
- To install, tighten to 23 Nm (17 lb-ft).
To install, reverse the removal procedure.