Rear Disc Brake Shield - All-Wheel Drive (AWD): Installation

WARNING: This page is about a different car, the 2009 Mercury Milan, 2009 Lincoln MKZ, and 2009 Ford Fusion. However, it is still accessible from the selected car via links, so may be relevant.

Transfer the index mark from the removed brake disc shield to the new brake disc shield.
Position the brake disc shield onto the wheel knuckle.
Align the index marks and install the brake disc shield onto the wheel knuckle using the Front Subframe Bushing Remover/Installer.

Fig 1: Aligning Index Marks & Installing Brake Disc Shield Onto Wheel Knuckle Using Special Tool (204-362/2)

Courtesy of FORD MOTOR CO.