Turn Signal/Hazard Lamps
WARNING: This page is about a different car, the 2009 Mercury Milan, 2009 Lincoln MKZ, and 2009 Ford Fusion. However, it is still accessible from the selected car via links, so may be relevant.
When the multifunction switch is placed in the LH or RH TURN positions, the SJB routes voltage to the LH or RH turn signal lamps. The SJB then cycles the voltage on and off approximately 80 times per minute. If a front or rear turn bulb is inoperative, the SJB cycles the voltage on and off approximately 160 times per minute.
The hazard switch is located in the instrument panel center finish panel. When the hazard switch is engaged, the SJB supplies voltage to all the turn lamps. The SJB cycles the voltage on and off approximately 80 times per minute.