Crankshaft Rear Seal: Removal

WARNING: This page is about a different car, the 2009 Lincoln MKZ. However, it is still accessible from the selected car via links, so may be relevant.

With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to JACKING AND LIFTING article.
Remove the flexplate. For additional information, refer to FLEXPLATE .
Remove the crankshaft sensor ring.
Using the Crankshaft Rear Oil Seal Remover and Slide Hammer, remove and discard the crankshaft rear seal.
- Clean all sealing surfaces with metal surface prep.

Fig 1: Removing Crankshaft Rear Seal Using Special Tools (303-519) & (307-005)

Courtesy of FORD MOTOR CO.