Valve Spring, Retainer, and Seal: Installation

WARNING: This page is about a different car, the 2009 Mercury Milan and 2009 Ford Fusion. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: Lubricate the valve guide with clean engine oil.

Using the Valve Stem Oil Seal Installer, install the new valve seal.

Fig 1: Installing Valve Seal

Courtesy of FORD MOTOR CO.

NOTE: If the components are to be reinstalled, they must be installed in their original positions or damage to the engine may occur.

Using the Valve Spring Compressor, install the valve spring, retainer and key.

Fig 2: Identifying Special Tool (303-473)

Courtesy of FORD MOTOR CO.

Install the camshaft roller followers. For additional information, refer to CAMSHAFT ROLLER FOLLOWER .