LEMON Manuals: Even more car manuals for everyone
Home >> Mercury >> 2008 >> Milan Base, 2.3 Z, Automatic >> Repair and Diagnosis >> External Pages >> Different car >> Section 1362 (Engine Mechanical - 3.0L (4V)) >> In-Vehicle Servicing >> Oil Level Indicator and Tube >> Removal And Installation

Removal And Installation

WARNING: This page is about a different car, the 2009 Mercury Milan and 2009 Ford Fusion. However, it is still accessible from the selected car via links, so may be relevant.
  1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to JACKING AND LIFTING article.
  2. Remove the oil level indicator.
  3. Remove the oil pressure sender. For additional information, refer to ENGINE OIL PRESSURE (EOP) SWITCH .
  4. If equipped, disconnect the block heater electrical connector and wiring harness retainers.
  5. Remove the stud bolt and the oil level indicator tube.
    • Discard the O-ring seal.
    • To install, tighten to 9 Nm (80 lb-in).
    6. NOTE: Install a new O-ring seal and lubricate with clean engine oil.
  6. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals