LEMON Manuals: Even more car manuals for everyone
Home >> Mercury >> 2008 >> Milan Base, 2.3 Z, Automatic >> Repair and Diagnosis >> External Pages >> Different car >> Section 1362 (Engine Mechanical - 3.0L (4V)) >> In-Vehicle Servicing >> Crankshaft Rear Seal >> Installation

Crankshaft Rear Seal: Installation

WARNING: This page is about a different car, the 2009 Mercury Milan and 2009 Ford Fusion. However, it is still accessible from the selected car via links, so may be relevant.
    NOTE: Clean all sealing surfaces with metal surface cleaner.
    NOTE: Apply clean engine oil to the seal lip and seal bore before installing the seal.
  1. Using the Crankshaft Rear Main Oil Seal Installer and the Crankshaft Rear Main Oil Seal Installer Bolts, install the crankshaft rear oil seal.
    2. Fig 1: Identifying Special Tools (303-384 And 303-178)
    G03898287Courtesy of FORD MOTOR CO.
  2. Install the flexplate. For additional information, refer to FLEXPLATE .
scientia non olet · About LEMON Manuals