LEMON Manuals: Even more car manuals for everyone
Home >> Mercury >> 2008 >> Milan Base, 2.3 Z, Automatic >> Repair and Diagnosis >> External Pages >> Different car >> Section 1362 (Engine Mechanical - 3.0L (4V)) >> In-Vehicle Servicing >> Crankshaft Pulley >> Removal

Crankshaft Pulley: Removal

WARNING: This page is about a different car, the 2009 Mercury Milan and 2009 Ford Fusion. However, it is still accessible from the selected car via links, so may be relevant.
  1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to JACKING AND LIFTING article.
  2. Remove the accessory drive belt. For additional information, refer to ACCESSORY DRIVE - 3.0L (4V) article.
  3. Use the Strap Wrench to hold the crankshaft pulley and remove the crankshaft pulley bolt and washer.
    4. Fig 1: Identifying Special Tool (303-D055) And Crankshaft Pulley Bolts
    GF0024221Courtesy of FORD MOTOR CO.
  4. Using the 3-Jaw Puller, remove the crankshaft pulley.
    5. Fig 2: Identifying Special Tools (303-D121) And Crankshaft Pulley
    GF0017017Courtesy of FORD MOTOR CO.
scientia non olet · About LEMON Manuals