LEMON Manuals: Even more car manuals for everyone
Home >> Mercury >> 2008 >> Milan Base, 2.3 Z, Automatic >> Repair and Diagnosis >> External Pages >> Different car >> Section 1362 (Engine Mechanical - 3.0L (4V)) >> In-Vehicle Servicing >> Crankshaft Front Seal >> Removal

Crankshaft Front Seal: Removal

WARNING: This page is about a different car, the 2009 Mercury Milan and 2009 Ford Fusion. However, it is still accessible from the selected car via links, so may be relevant.
  1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to JACKING AND LIFTING article.
  2. Remove the crankshaft pulley. For additional information, refer to CRANKSHAFT PULLEY .
  3. Using the Oil Seal Remover, remove and discard the crankshaft front seal.
    4. Fig 1: Removing Crankshaft Front Seal Using Special Tool (303-409)
    GF0024224Courtesy of FORD MOTOR CO.
scientia non olet · About LEMON Manuals