LEMON Manuals: Even more car manuals for everyone
Home >> Mercury >> 2008 >> Milan Base, 2.3 Z, Automatic >> Repair and Diagnosis >> External Pages >> Different car >> Section 1362 (Engine Mechanical - 3.0L (4V)) >> In-Vehicle Servicing >> Crankshaft Front Seal >> Installation

Crankshaft Front Seal: Installation

WARNING: This page is about a different car, the 2009 Mercury Milan and 2009 Ford Fusion. However, it is still accessible from the selected car via links, so may be relevant.
    NOTE: Clean all sealing surfaces with metal surface prep.
  1. Apply clean engine oil to the seal lip and seal bore before installing the seal.
  2. Using the Crankshaft Vibration Damper Installer and the Front Cover Oil Seal Installer, install a new crankshaft front seal.
    3. Fig 1: Installing Crankshaft Seal Using Special Tools (303-335 And 303-102)
    G03898281Courtesy of FORD MOTOR CO.
  3. Install the crankshaft pulley. For additional information, refer to CRANKSHAFT PULLEY .
scientia non olet · About LEMON Manuals