LEMON Manuals: Even more car manuals for everyone
Home >> Mercury >> 2008 >> Milan Base, 2.3 Z, Automatic >> Repair and Diagnosis >> External Pages >> Different car >> Section 1357 (Accessory Drive System - 3.0L (4V)) >> Removal And Installation >> Accessory Drive Belt >> Removal And Installation

Removal And Installation

WARNING: This page is about a different car, the 2009 Mercury Milan and 2009 Ford Fusion. However, it is still accessible from the selected car via links, so may be relevant.
  1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to JACKING AND LIFTING article.
  2. Remove the 4 screws and position the RH fender splash shield aside.
    3. Fig 1: Locating RH Fender Splash Shield Screws
    G04684102Courtesy of FORD MOTOR CO.
  3. Remove the 6 pin-type retainers and the RH splash shield.
  4. Using a suitable belt tensioner release tool, rotate the accessory drive belt tensioner counterclockwise and remove the accessory drive belt.
  5. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals