Catalytic Converter - 3.0L RH Manifold, Front Wheel Drive (FWD): Removal
WARNING: This page is about a different car, the 2009 Mercury Milan, 2009 Lincoln MKZ, and 2009 Ford Fusion. However, it is still accessible from the selected car via links, so may be relevant.
- With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to JACKING AND LIFTING article.
- Remove the exhaust flexible pipe. For additional information, refer to EXHAUST FLEXIBLE PIPE - 2.3L, 3.0L .
- Remove the EGR tube. For additional information, refer to ENGINE EMISSION CONTROL - 3.0L (4V) article.
- Disconnect the Heated Oxygen Sensor (HO2S) and catalyst monitor sensor electrical connectors.
- Remove the 2 bolts and the RH catalytic converter manifold shield.
- Remove the 2 RH catalytic converter manifold shield bracket bolts and the shield bracket.
- Loosen the 2 RH catalytic converter manifold bracket bolts.
- Remove the 6 nuts and the RH catalytic converter manifold.
- Discard the 6 RH catalytic converter manifold nuts and gasket.
- Remove the 6 RH catalytic converter manifold studs and discard.
- Clean and inspect the catalytic converter manifold. For additional information, refer to ENGINE SYSTEM - GENERAL INFORMATION article.