Toe Adjustment - Rear

WARNING: This page is about a different car, the 2009 Mercury Milan, 2009 Lincoln MKZ, and 2009 Ford Fusion. However, it is still accessible from the selected car via links, so may be relevant.

Using alignment equipment and the manufacturer's instructions, measure the rear toe.
Loosen the toe link jam nuts.

Fig 1: Locating Toe Link Jam Nuts

Courtesy of FORD MOTOR CO.

Rotate the toe link adjusting rod until the toe setting is within specifications.

Fig 2: Locating Toe Link Adjusting Rod

Courtesy of FORD MOTOR CO.

NOTE: Do not allow the adjusting rod to rotate while tightening the jam nuts.

Tighten the toe link jam nuts to 84 Nm (62 lb-ft).
Recheck the rear toe and adjust as necessary.