240,000 Km (150,000 Mi)
WARNING: This page is about a different car, the 2009 Mercury Milan, 2009 Lincoln MKZ, and 2009 Ford Fusion. However, it is still accessible from the selected car via links, so may be relevant.
- Change engine oil and install a new oil filter.
- Change engine coolant.
- Install a new cabin air filter (if equipped).
- Install new climate controlled seat cushion filters (if equipped).
- Install a new engine air filter (except Focus with PZEV engine).
- Install a new fuel filter (not required for Fusion, Milan, MKZ, Edge, MKX, Taurus X, Taurus, Focus, Sable, E-Series, Expedition and Navigator with short wheelbase, F-150, Flex, MKS, Escape and Mariner).
- Install a new automatic transmission/transaxle filter (except for 6F35, 6F50, AWF-21, FNR5, and TorqShift® transmissions).
- Change manual transmission fluid (if equipped) (except Escape).
- Change automatic transmission/transaxle fluid (except TorqShift®).
- Replace rear axle lubricant on all RWD vehicles.
- Install new front wheel bearings (if not sealed units).
- Install a new accessory drive belt(s) (if a new belt has not been installed within the last 160,000 km [100,000 mi]).
- Inspect engine cooling system and hoses.
- Inspect brake pads, shoes, rotors, drums, brake lines, hoses and parking brake system.
- Inspect halfshaft boots (if equipped).
- Change front differential fluid, 4WD (if equipped).
- Change transfer case fluid, 4WD (if equipped).
- Inspect exhaust system and heat shields.
- Inspect PVC for flow (3V engines).
- Inspect and lubricate control arms, steering linkage, steering ball joints, U-joints and driveshaft with zerk fittings (if equipped).
- Inspect and lubricate 4WD front axle shaft U-joints (if equipped).
- Perform multi-point inspection (recommended).
- Rotate tires, inspect tires for wear, measure tread depth and inspect wheel ends for end play and noise. Vehicles with dual rear wheels should only be rotated if unusual wear is noted. For vehicles with different front-to-rear tire pressures, the tire pressure must be adjusted and the tire pressure sensor training must be done.