192,000 Km (120,000 Mi)
WARNING: This page is about a different car, the 2009 Mercury Milan, 2009 Lincoln MKZ, and 2009 Ford Fusion. However, it is still accessible from the selected car via links, so may be relevant.
- Change engine oil and install a new oil filter.
- Install a new cabin air filter (if equipped).
- Install new climate controlled seat cushion filters (if equipped).
- Install a new engine air filter (except Focus with PZEV engine).
- Install a new fuel filter (not required for Fusion, Milan, MKZ, Edge, MKX, Taurus X, Taurus, Focus, Sable, E-Series, Expedition and Navigator with short wheelbase, F-150, Flex, MKS, Escape and Mariner).
- Install a new PCV valve on all cars and light trucks over 6,000 lb GVW (except 3V engines).
- Change automatic transmission/transaxle fluid on all vehicles equipped with the TorqShift® transmissions.
- Install a new internal TorqShift® transmission fluid filter located inside the transmission bottom pan.
- Inspect automatic transmission/transaxle fluid level on all other vehicles (if equipped with an underhood fluid level indicator).
- Inspect and lubricate control arms, steering linkage, steering ball joints, U-joints and driveshaft with zerk fittings (if equipped).
- Inspect engine cooling system and hoses.
- Inspect brake pads, shoes, rotors, drums, brake lines, hoses and parking brake system.
- Inspect halfshaft boots (if equipped).
- Inspect exhaust system and heat shields.
- Inspect accessory drive belts.
- Replace wheel bearing grease and install new grease seals on RWD front wheel bearings (if non-sealed bearings).
- Inspect and lubricate 4WD front axle shaft U-joints (if equipped).
- Perform multi-point inspection (recommended).
- Rotate tires, inspect tires for wear, measure tread depth and inspect wheel ends for end play and noise. Vehicles with dual rear wheels should only be rotated if unusual wear is noted. For vehicles with different front-to-rear tire pressures, the tire pressure must be adjusted and the tire pressure sensor training must be done.