Removal And Installation
WARNING: This page is about a different car, the 2009 Mercury Grand Marquis and 2009 Ford Crown Victoria. However, it is still accessible from the selected car via links, so may be relevant.
| Item | Part Number | Description |
|---|---|---|
| 1 | 14A464 | Camshaft position (CMP) sensor electrical connector |
| 2 | N806155 | CMP sensor bolt |
| 3 | 6B288 | CMP sensor |
- Disconnect the camshaft position (CMP) sensor electrical connector.
- Remove the bolt and the CMP.
- To install, tighten to 10 Nm (89 lb-in).
- Remove the CMP sensor.
- To install, reverse the removal procedure.