LEMON Manuals: Even more car manuals for everyone
Home >> Mercury >> 2008 >> Milan Base, 2.3 Z, Automatic >> Repair and Diagnosis >> External Pages >> Different car >> Section 1227 (Handles, Locks, Latches & Entry Systems) >> Removal And Installation >> Door Lock Cylinder >> Removal And Installation

Removal And Installation

WARNING: This page is about a different car, the 2009 Ford Mustang. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the door trim panel. For additional information, refer to INTERIOR TRIM AND ORNAMENTATION .
  2. Position the watershield aside.
  3. Disconnect the door lock cylinder actuating rod.
    4. Fig 1: Locating Door Lock Cylinder Actuating Rod
    GF0014848Courtesy of FORD MOTOR CO.
  4. If equipped, disconnect the door disarm switch wiring harness electrical connector.
  5. Remove the bolt and the door lock cylinder.
    • To install, tighten to 9 Nm (80 lb-in).
    6. Fig 2: Locating Door Lock Cylinder And Bolt
    GF0014852Courtesy of FORD MOTOR CO.
  6. To install, reverse the removal procedure.
    • Lubricate the door lock cylinder after installation.
scientia non olet · About LEMON Manuals