Removal And Installation

WARNING: This page is about a different car, the 2008 Mercury Mariner and 2008 Ford Escape. However, it is still accessible from the selected car via links, so may be relevant.

Remove the front door trim panel. For additional information, refer to INTERIOR TRIM AND ORNAMENTATION article.
Remove the screw and the front door trim panel bracket.

Fig 1: Identifying Screw

Courtesy of FORD MOTOR CO.

Remove the 3 pushpins and pad assembly.

Fig 2: Identifying Pushpins

Courtesy of FORD MOTOR CO.

Position the watershield aside.
Connect the window control switch electrical connector.
Using the window control switch, lower the front door window glass to gain access to the front door window glass screws.
Disconnect the window control switch electrical connector.
Remove the 2 front door window glass screws.
- To install, tighten to 5 Nm (44 lb-in).

Fig 3: Door Window Glass Screws

Courtesy of FORD MOTOR CO.

Support the front door window glass in the full up position with tape.
Disconnect the front door window motor electrical connector.
Remove the front door window regulator and motor bolt.
- To install, tighten to 11 Nm (8 lb-ft).

Fig 4: Identifying Bolt

Courtesy of FORD MOTOR CO.

Loosen the 2 front door window regulator and motor bolts.
- To install, tighten to 11 Nm (8 lb-ft).

Fig 5: Identifying Bolts

Courtesy of FORD MOTOR CO.

Remove the 2 nuts and the front door window regulator and motor.
- To install, tighten to 11 Nm (8 lb-ft).

Fig 6: Identifying Nuts

Courtesy of FORD MOTOR CO.

To install, reverse the removal procedure.