Removal And Installation
WARNING:
Do not use any fluid other than clean brake fluid meeting manufacturer's specification. Additionally, do not use brake fluid that has been previously drained. Following these instructions will help prevent system contamination, brake component damage and the risk of serious personal injury.
WARNING:
Carefully read cautionary information on product label. For EMERGENCY MEDICAL INFORMATION seek medical advice. In the USA or Canada on Ford/Motorcraft products call: 1-800-959-3673. For additional information, consult the product Material Safety Data Sheet (MSDS) if available. Failure to follow these instructions may result in serious personal injury.
CAUTION:
Brake fluid is harmful to painted and plastic surfaces. If brake fluid is spilled onto a painted or plastic surface, immediately wash it with water.
- Disconnect the brake fluid level warning switch electrical connector.
- Using a suitable suction device, remove the brake fluid from the brake master cylinder reservoir.
- If equipped with a manual transmission, disconnect the clutch master cylinder feed hose.
- Plug the clutch master cylinder feed hose.
- Disconnect the brake tube fittings, plug the brake tubes and the brake master cylinder ports.
- To install, tighten to 17 Nm (150 lb-in).
- Remove the 2 brake master cylinder nuts.
- To install, tighten to 25 Nm (18 lb-ft).
- Remove the brake master cylinder.
- To install, reverse the removal procedure.
- Bleed the master cylinder. For additional information, refer to BRAKE SYSTEM - GENERAL INFORMATION article.
- If equipped with a manual transmission, bleed the clutch master cylinder. For additional information, refer to MANUAL TRANSAXLE/TRANSMISSION AND CLUTCH - GENERAL INFORMATION article.