Instrument Cluster (IC): Installation

MKZ 

1. Position the instrument cluster (IC) in the instrument panel.
   • Connect the electrical connector.
   • Install the 2 screws.
2. Position the instrument cluster (IC) finish panel and install the 2 screws.

Fusion, Milan 

NOTE: Position the bottom portion of the instrument cluster (IC) on the instrument panel locator pins first then rotate the top of the instrument cluster (IC) into position.
3. Position the instrument cluster (IC) in the instrument panel.
   • Connect the electrical connector.
   • Install the 2 screws.
4. Install the instrument cluster (IC) finish panel.

All vehicles 

5. If a new instrument cluster (IC) was installed, download the instrument cluster (IC) configuration information from the scan tool into the new instrument cluster (IC). For additional information, refer to MODULE CONFIGURATION article, PMI.
NOTE: If a new instrument cluster (IC) is installed, updated, or re-configured, the instrument cluster and the powertrain control module (PCM) require a parameter reset to allow the instrument cluster (IC) and the PCM to recognize each other. Failure to carry out the parameter reset to the instrument cluster (IC) and the PCM may result in a no start condition.
6. If a new instrument cluster (IC) was installed, updated or reconfigured, carry out the parameter reset procedure. For additional information, refer to ANTI-THEFT - PASSIVE ANTI-THEFT SYSTEM (PATS) article.
NOTE: The vehicles integrated keys (or standard passive anti-theft system [PATS] keys) must be programmed to the new instrument cluster.
7. If a new instrument cluster (IC) was installed, program the integrated keys. For additional information, refer to ANTI-THEFT - PASSIVE ANTI-THEFT SYSTEM (PATS) article.