Pinpoint Test AK: The Turn Signal Left On Warning Chime Is Inoperative

AK1 CHECK THE TURN SIGNAL INDICATORS OPERATION
- Key in ON position.
- Verify the turn signal indicators operation.
- Do the turn signal indicators operate correctly?
1. YES : Go to AK2.
2. NO : Go to Pinpoint Test Q .
AK2 CHECK THE ODOMETER FOR CORRECT OPERATION
- Drive the vehicle and observe the odometer for correct operation.
- Does the odometer operate correctly?
1. YES : Go to AK3.
2. NO : Go to Pinpoint Test F .
AK3 CHECK FOR CORRECT INSTRUMENT CLUSTER (IC) OPERATION
- Disconnect the instrument cluster (IC) connector.
- Check for:
  - corrosion
  - damaged pins
  - pushed-out pins
- Connect the instrument cluster (IC) connector and make sure it seats correctly.
- Operate the system and verify the concern is still present.
- Is the concern still present?
1. YES : INSTALL a new instrument cluster (IC). REFER to Instrument Cluster (IC) . TEST the system for normal operation.
2. NO : The system is operating correctly at this time. The concern may have been caused by a loose or corroded connector.