Wheel Bearings, Wheel Hub Seal and Wheel Bearing Cups: Installation
WARNING: This page is about a different car, the 2007 Ford Pickup, 2007 Ford F550 Super Duty, 2007 Ford F450 Super Duty, and 2007 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
- For model 80, using the special tools 205-098, 205-100, and 205-278, install the inner and outer bearing cups. For model S110 or S130, use a suitable driver.
- Check to see if a 0.038 mm (0.0015 inch) feeler gauge can be inserted between the cups and the rear hub at any point around each cup. Reseat the bearing cups, if necessary.
- Install the inner rear wheel bearing in the rear hub.
- Install a new rear hub seal.
- For model 80, use a suitable seal installer.
- For model S110 or S130, use special tools 205-445 and 205-153.
- Position the rear brake disc on the rear hub and install the bolts.
- Tighten to 105 Nm (67 lb-ft).
- Install the rear hub and brake disc assembly. For additional information, refer to Wheel Hub in this article.