Removal and Installation

WARNING: This page is about a different car, the 2006 Ford Pickup, 2006 Ford F550 Super Duty, 2006 Ford F450 Super Duty, and 2006 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.

WARNING: The evaporative emissions system contains fuel vapor and condensed fuel vapor. Although not present in large quantities, it still presents the danger of explosion or fire. Disconnect the battery ground cable from the battery to minimize the possibility of an electrical spark occurring, possibly causing a fire or explosion if fuel vapor or liquid fuel are present in the area. Failure to follow these instructions can result in personal injury.

WARNING: Do not smoke or carry lighted tobacco or open flame of any type when working on or near any fuel-related component. Highly flammable mixtures are always present and may be ignited. Failure to follow these instructions may result in personal injury.

All vehicles

With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to JACKING & LIFTING .
Remove the fuel tank. For additional information, refer to FUEL TANK & LINES - GASOLINE AND DIESEL .

Midship fuel tank equipped vehicles

Disconnect the fuel tank pressure sensor electrical connector.
Disconnect the fuel vapor tubes from the fuel pressure sensor.
Remove the fuel pressure sensor.

Aft-of-axle fuel tank equipped vehicles

CAUTION: The fuel tank pressure sensor must be disengaged from the fuel tank before it can be removed. Push down while rotating the sensor counterclockwise to disengage it from the fuel tank. Failure to do so can cause damage to the fuel tank pressure sensor or the fuel tank.

Fig 1: Rotating Fuel Tank Pressure Sensor

Courtesy of FORD MOTOR CO.

Press down and rotate the fuel tank pressure sensor counterclockwise and remove it from the fuel tank.

All vehicles

To install, reverse the removal procedure.
- Carry out the evaporative emission system leak test. For additional information, refer to EVAPORATIVE EMISSION SYSTEM LEAK TEST .
- Carry out the evaporative emissions repair verification drive cycle. For additional information, refer to EVAPORATIVE EMISSION REPAIR VERIFICATION DRIVE CYCLE .