Vehicle with dual generators

WARNING: This page is about a different car, the 2007 Ford Pickup, 2007 Ford F550 Super Duty, 2007 Ford F450 Super Duty, and 2007 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Identifying Generator Mounting Bracket Bolts

Courtesy of FORD MOTOR CO.

Install the secondary generator with mounting bracket and bolts.
- Tighten to 47 Nm (35 lb-ft).

Fig 2: Locating Wire Retainer And Generator Electrical Connectors

Courtesy of FORD MOTOR CO.

Connect the B+ wire, secondary generator electrical connector and wire retainer.
- Tighten to 8 Nm (71 lb-in).

Fig 3: Locating Accessory Drive Belt Tensioner Bolts

Courtesy of FORD MOTOR CO.

Install the primary accessory drive belt tensioner and bolts.
- Tighten to 25 Nm (18 lb-ft).

Fig 4: Locating Bracket And Accessory Drive Belt Idler Pulley Bolts

Courtesy of FORD MOTOR CO.

Position the secondary accessory drive belt idler pulley. Install the bracket and bolts.
- Tighten to 25 Nm (18 lb-ft).

Fig 5: Rotating Accessory Drive Belt Tensioner

Courtesy of FORD MOTOR CO.

Install the primary accessory drive belt.

Fig 6: Locating Accessory Drive Belt Tensioner Bolt

Courtesy of FORD MOTOR CO.

Install the secondary accessory drive belt tensioner and bolt.
- Tighten to 25 Nm (18 lb-ft).

Fig 7: Rotating Drive Belt Tensioner Clockwise

Courtesy of FORD MOTOR CO.

Install the secondary accessory drive belt.