LEMON Manuals: Even more car manuals for everyone
Home >> Mercury >> 2002 >> Villager Base >> Repair and Diagnosis >> External Pages >> Different car >> Section 39 (Engine Removal, Overhaul & Installation -- ECONOLINE, Excursion & F250-F550 Super Duty - Diesel 7.3L (99F E Series & 99F F450/550)) >> Engine Sensors & Switches >> Camshaft Position Sensor >> Removal & Installation

Removal & Installation

WARNING: This page does not describe the selected car, but rather 10 other vehicles, including the 2002 Ford RV Cutaway, 2002 Ford Pickup, 2002 Ford F550 Super Duty, 2002 Ford F450 Super Duty, and 2002 Ford Excursion. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect Camshaft Position Sensor (CMP) harness connector, located at front of engine above crankshaft pulley.
  2. Remove bolt and CMP sensor.
  3. To install, reverse removal procedure. Tighten bolt to specification. See TORQUE SPECIFICATIONS .
scientia non olet · About LEMON Manuals