LEMON Manuals: Even more car manuals for everyone
Home >> Mercury >> 2000 >> Villager Estate >> Repair and Diagnosis >> Steering >> Steering Column - Trucks - Except Excursion, E350, F250-550 Super Duty & Stripped Chassis >> Removal & Installation >> Lock Cylinder >> Removal & Installation (Villager - With Key)

Removal & Installation (Villager - With Key)

  1. Disconnect battery ground cable. Remove lower and upper steering column shroud. Turn ignition switch on. Remove 2 screws and key-in-reminder switch.
  2. Place 1/8" (3.18 mm) diameter wire pin or small drift in access hole in lock housing under ignition switch lock cylinder. Depress retaining pin while pulling on ignition switch lock cylinder. To install, reverse removal procedure.
scientia non olet · About LEMON Manuals