LEMON Manuals: Even more car manuals for everyone
Home >> Mercury >> 2000 >> Villager Estate >> Repair and Diagnosis >> Steering >> Steering Column - Trucks - Except Excursion, E350, F250-550 Super Duty & Stripped Chassis >> Removal & Installation >> Lock Cylinder >> Removal & Installation (All Models Except Villager - Without Key)

Removal & Installation (All Models Except Villager - Without Key)

NOTE: Removal and installation procedures for ignition lock cylinder without key are not available for Escape.
  1. Ensure front wheels are in straight-ahead position. Disconnect battery negative cable. Wait one minute to deplete air bag backup power supply. Remove steering wheel assembly. See STEERING WHEEL & AIR BAG . Twist off cap from ignition switch cylinder. Remove upper and lower steering column shrouds. Disconnect key warning switch electrical connector.
  2. Use a 1/8" (3.18 mm) drill bit to drill out retaining pin. Use a 3/8" (9.5 mm) drill bit to drill down middle of ignition lock key slot until ignition switch lock cylinder breaks loose. Remove and discard ignition switch lock cylinder, and clean drill shavings from steering column.
  3. Remove bearing retainer. Remove bearing and gear. On all models, install reverse removal procedure. Check for normal ignition switch lock cylinder operation.
scientia non olet · About LEMON Manuals