LEMON Manuals: Even more car manuals for everyone
Home >> Mercury >> 2000 >> Villager Estate >> Repair and Diagnosis >> Electrical >> Gauges >> Instrument Panels - Analog >> System Tests >> Test O: Low Washer Fluid Indicator Inoperative

Test O: Low Washer Fluid Indicator Inoperative

  1. Turn ignition switch to LOCK position. Disconnect washer fluid level switch 2-pin harness connector C111 at washer fluid reservoir. Measure resistance between washer fluid level switch terminals. If resistance is 5 ohms or less with float depressed and greater than 10 k/ohms with float released, go to next step. If resistance is greater than 5 ohms with float depressed or 10 k/ohms or less with float released, replace washer fluid level switch.
  2. Measure resistance between ground and terminal No. 1 (Black wire) at washer fluid level switch harness connector C111. If resistance is 5 ohms or less, go to next step. If resistance is greater than 5 ohms, repair open in Black wire.
  3. Turn ignition switch to LOCK position. Remove instrument cluster. See INSTRUMENT CLUSTER  under REMOVAL & INSTALLATION. Disconnect instrument cluster harness connector C266b. Measure resistance of Green/Black wire between terminal No. 2 at washer fluid level switch harness connector C111 and terminal No. 1 at instrument cluster harness connector C266c. See Figure. If resistance is 5 ohms or less, replace instrument cluster printed circuit. See PRINTED CIRCUIT  under REMOVAL & INSTALLATION. If resistance is greater than 5 ohms, repair open in Green/Black wire.
scientia non olet · About LEMON Manuals