Test P: Safety Belt Warning Inoperative (Chime Operative)
- Disconnect safety belt buckle switch connector. Connect a fused jumper wire between ground and safety belt buckle switch connector Green wire terminal. Turn ignition on. If safety belt light illuminates, go to next step. If safety belt light does not illuminate, go to step 3.
- Turn ignition switch off. Remove instrument cluster. See ELECTRONIC INSTRUMENT CLUSTER under REMOVAL & INSTALLATION. Disconnect instrument cluster connector C267C. Measure resistance of Green wire between safety belt buckle switch connector and instrument cluster connector C267C terminal No. 9. See Figure. If resistance is less than 5 ohms, replace instrument cluster. See ELECTRONIC INSTRUMENT CLUSTER under REMOVAL & INSTALLATION. Retest system. If resistance is 5 ohms or more, repair open in Green wire. Retest system.
- Measure resistance between ground and safety belt buckle switch Black wire terminal. If resistance is less than 5 ohms, replace safety belt buckle switch connector. If resistance is more than 5 ohms, repair open in Black wire.