Test Z: Right Turn Indicator Never/Always On
- Turn ignition on. Turn right turn signal on. If turn signal operates normally, go to next step. If turn signal does not operate normally, repair or replace as necessary.
- Turn ignition off. Remove instrument cluster. See REMOVAL & INSTALLATION. Remove indicator bulb. Check for continuity between indicator bulb terminals. If continuity is present, go to next step. If continuity is not present, replace bulb.
- Turn ignition off. Disconnect instrument cluster connector C276. See Figure . Turn ignition on. Turn right signal on. Measure voltage between ground and instrument cluster connector C276, pin No. 3 (Red/White wire). If voltage alternates 0-10 volts, replace instrument cluster. If voltage is not as specified, repair open or short in Red/White wire.