LEMON Manuals: Even more car manuals for everyone
Home >> Mercury >> 1996 >> Villager LS >> Repair and Diagnosis >> Accessories & Equipment >> Gauges & Instrument Panels >> Instrument Panel - Electronic >> Testing >> Pinpoint Test Q - Trip Distance Does Not Accumulate

Pinpoint Test Q - Trip Distance Does Not Accumulate

  1. Turn ignition off. Disconnect message center switch module connector. Remove instrument cluster. See REMOVAL & INSTALLATION  . Disconnect instrument cluster connector C3. Measure resistance of Red/Blue wire between message center control module connector and instrument cluster connector C3, pin No. 13. Resistance should be less than 5 ohms. Measure resistance of Red/Blue wire between ground and message center switch module connector. Resistance should be greater than 10,000 ohms. If resistances are as specified, go to next step. If resistances are not as specified, repair Red/Blue wire circuit.
  2. Leave ignition off and instrument cluster connector C3 disconnected. Reconnect message center control module connector. Turn ignition on. Press OD/TRIP switch (located on message center). Measure voltage between ground and instrument cluster connector C3, pin No. 13 (Red/Blue wire). If voltage is greater than 10 volts, replace instrument cluster. If voltage is less than 10 volts, replace message center control module.
scientia non olet · About LEMON Manuals