AC11: Bulb Check Relay
With the ignition key in thee OFF position, remove the bulb check relay. Using a jumper, connect terminal 2 of the bulb check relay to the battery positive terminal. Measure the resistance between terminal 3 and terminal 5 of the bulb check relay. See RESISTANCE BETWEEN TERMINALS .
RESISTANCE BETWEEN TERMINALS
| Terminal 1 | Resistance |
|---|---|
| Connected To The Battery Negative Cable | Les Than 5 ohms |
| Not Connected | Greater Than 10,000 ohms |
Are the resistances OK? If yes, go to the next step. If no, replace the bulb check relay.