LEMON Manuals: Even more car manuals for everyone
Home >> Mercury >> 1993 >> Capri Base, Standard >> Repair and Diagnosis >> Engine Mechanical >> Mechanical >> 1.3L 4-CYL - VIN [H] & 1.6L 4-CYL DOHC - VINS [Z,6] >> Removal & Installation >> Rear Main Bearing Oil Seal >> Installation (1.6L)

Installation (1.6L)

Lubricate oil seal lip with engine oil. Using Rear Main Seal Installer (T87C-6701-A) and Screw Set (T90P-6701-AH), install rear main bearing oil seal. To complete installation, install flywheel or flexplate. Apply Threadlock/Sealer (E0AZ-19554/ESE-M4G204A) to flywheel retaining bolts. Tighten bolts to specification. See, at the end of this article, TORQUE SPECIFICATIONS TABLE . Install clutch assembly (if equipped) and transaxle.

scientia non olet · About LEMON Manuals