LEMON Manuals: Even more car manuals for everyone
Home >> Mercury >> 1993 >> Capri Base, Standard >> Repair and Diagnosis >> Engine Mechanical >> Mechanical >> 1.3L 4-CYL - VIN [H] & 1.6L 4-CYL DOHC - VINS [Z,6] >> Removal & Installation >> Oil Pan >> Installation (1.6L)

Installation (1.6L)

  1. Clean pan and block gasket surfaces. Apply Gasket Sealant (E8AZ-19562-A) to new front and rear pan seals. Install seals to cylinder block. Apply Gasket Sealant (E3AZ-19562-A) to oil pan gasket surface. Install oil pan and tighten pan retaining bolts to specification. See TORQUE SPECIFICATIONS TABLE  at the end of this article.
  2. Connect turbocharger oil return hose (if equipped). Install rubber exhaust hanger to brackets. Install new gasket and connect front exhaust pipe to exhaust manifold (or turbocharger). Install front exhaust pipe bracket. Tighten nuts and bolts to specification.
  3. Pivot frame brace into position. Tighten retaining bolt to crossmember and right "A" arm front retaining bolt to specification. Lower vehicle, fill with oil and start engine. Check for oil leaks and system operation.
scientia non olet · About LEMON Manuals