LEMON Manuals: Even more car manuals for everyone
Home >> Mercury >> 1993 >> Capri Base, Standard >> Repair and Diagnosis >> Engine Mechanical >> Mechanical >> 1.3L 4-CYL - VIN [H] & 1.6L 4-CYL DOHC - VINS [Z,6] >> Overhaul >> Cylinder Block Assembly >> Fitting Pistons

Fitting Pistons

  1. With piston assembly removed, remove piston rings and clean piston. Measure piston outer diameter in thrust direction, below oil ring groove. Diameter is 2.793-2.794" (70.954-70.974 mm) for 1.3L engines; 3.0690-3.0698" (77.954-77.974) for 1.6L engines.
  2. Place piston upside-down in cylinder from which it was removed. Using a feeler gauge, measure clearance between piston and cylinder bore. If clearance is not within specification, bore cylinder and replace piston as necessary. See CYLINDER BLOCK  table in ENGINE SPECIFICATIONS.
scientia non olet · About LEMON Manuals