Installation (1.3L)

Clean seal surface in retainer. Lubricate oil seal inside and outside. Install seal retainer on engine. Install seal in retainer with hollow side of seal facing engine. Using Rear Main Seal Installer (T87C-6701-A), install rear main bearing oil seal. Flywheel bolts may be used to press seal installer and seal into cover plate. Install seal retainer and cover plate. If necessary, trim excess gasket material off seal retainer. Tighten plate bolts to 71-97 INCH lbs. (8-11 N.m). Install flywheel or flexplate and transaxle.