LEMON Manuals: Even more car manuals for everyone
Home >> Mercury >> 1992 >> Capri Base, Automatic >> Repair and Diagnosis >> Engine Mechanical >> Mechanical >> 1.3L 4-CYL - VIN [H] & 1.6L 4-CYL - VINS [Z,6] >> Removal & Installation >> Cylinder Head >> Installation (1.3L)

Installation (1.3L)

  1. Place new head gasket properly on block. Carefully place cylinder head in position on block. Install head bolts. Tighten bolts in sequence and in 2 steps. See Fig 1.
  2. While tightening rocker arm shaft, slide shaft springs away from retaining bolt to prevent pinching springs. Tighten rocker arm shaft bolts in sequence and to specification. See Figure. To complete installation, reverse removal procedure. Tighten all bolts/nuts to specification. Fill all fluids to proper levels.
Fig 1: Installing Cylinder Head Bolts (1.3L)
G60094Courtesy of FORD MOTOR CO.
scientia non olet · About LEMON Manuals