LEMON Manuals: Even more car manuals for everyone
Home >> Mercury >> 1992 >> Capri Base, Automatic >> Repair and Diagnosis >> Engine Mechanical >> Mechanical >> 1.3L 4-CYL - VIN [H] & 1.6L 4-CYL - VINS [Z,6] >> Removal & Installation >> Camshaft >> Removal (1.6L)

Removal (1.6L)

  1. Disconnect battery ground terminal. Disconnect air by-pass hoses, and remove intake air tube. Disconnect throttle cable, and remove retaining brackets. Remove cam cover. Remove timing belt.
  2. Hold camshaft with wrench while removing pulley retaining bolt. Remove camshaft pulley(s). Remove seal plate. Remove camshaft seal using Seal Remover (T78P-3504-N). If removing intake cam, remove distributor.
  3. Note numerical and directional markings on camshaft bearing caps for installation. Remove bearing cap retaining bolts alternately and gradually to prevent overstressing camshaft. Remove camshaft.
scientia non olet · About LEMON Manuals