Removal and Installation

Removal

1. Disconnect negative battery cable.

2. Remove engine damper strut.

3. Remove power steering belt.

4. Raise vehicle on hoist.

5. Remove right front wheel and tire assembly.

6. Position jack under engine. Remove right rear engine mount.

7. Remove power steering pump pulley.

8. Position drain pan. Remove pressure and return lines from pump.

9. Remove four pump retaining bolts (three in front, one in rear) and remove pump.

Installation

1. Position pump and install retaining bolts. Tighten retaining bolts to 20-32.5 N-m (15-24 lb-ft).

2. Install pressure and return lines to pump. Remove drain pan.

3. Install power steering pump pulley.

4. Install right rear engine mount and remove jack.

5. Install right front wheel and tire assembly. Tighten wheel lug nuts to 115-142 N-m (85-105 lb-ft).

6. Lower vehicle.

7. Install belt to pump pulley.

8. Install engine damper strut.

9. Connect negative battery cable.

10. Fill power steering fluid to proper level.