LEMON Manuals: Even more car manuals for everyone
Home >> Mercury >> 1991 >> Capri XR2 >> Repair and Diagnosis >> Accessories & Equipment >> Gauges & Instrument Panels >> Testing >> Oil Pressure Gauge (CAPRI)

Oil Pressure Gauge (CAPRI)

  1. Remove electrical connector from oil pressure sending unit located on right side of engine block. Turn ignition switch on. Oil pressure gauge should read low. Install a jumper wire between Yellow/Red wire of oil pressure sending unit vehicle harness connector and ground. Oil pressure gauge should read high.
  2. If oil pressure gauge operates as specified, replace sending unit. If gauge does not operate as specified, check instrument panel power and ground circuits.
scientia non olet · About LEMON Manuals