LEMON Manuals: Even more car manuals for everyone
Home >> Mercury >> 1982 >> Lynx RS, Automatic Trans >> Repair and Diagnosis >> Suspension >> Rear Suspension >> Rear Suspension - Ford Motor Co. Front Wheel Drive >> Removal & Installation >> Wheel Bearings >> Removal

Wheel Bearings: Removal

  1. Raise vehicle until tire clears floor. Remove wheel from hub and drum. Remove grease cap from hub, taking care not to damage cap. Remove cotter pin, nut retainer, adjusting nut and flat washer from spindle.
  2. Pull hub and drum assembly off the spindle without dropping outer bearing assembly. Remove outer bearing assembly. Using seal remover tool (1175-AC or equivalent), remove and discard grease seal. Remove inner bearing from hub.
scientia non olet · About LEMON Manuals