Wheel Bearings: Installation
- If inner or outer bearing cups were removed, install replacement cups using installer tools (T77F-1102-A and T77F-1217-A or equivalent). Support drum on wood block to prevent damage. Make sure all spindle and bearing surfaces are clean.
- Thoroughly grease bearing and install inner bearing and cone into inner cup. Apply a light film of grease to the lips of new grease seal and install the seal with seal installer (T81P-1249-A or equivalent). Be sure seal retainer flange is seated all around. Apply a light coat of grease on spindle shaft bearing surfaces.
- Install hub and drum assembly on spindle. Keep hub centered on spindle. Install outer bearing assembly and flat washer on spindle. Install adjusting nut finger tight. Adjust bearings. Install grease cap. Install wheel and tire and lower vehicle.
TIGHTENING SPECIFICATIONS
| Application | Ft.Lbs. (N.m) |
|---|---|
| Shock Absorber-to-Body | 30-55 (41-75) |
| Shock Absorber-to-Spindle | 90-100 (122-136) |
| Control Arm-to-Body | 65-75 (88-102) |
| Control Arm-to-Spindle | 90-100 (122-136) |
| Tie Rod-to-Body | 90-100 (122-136) |
| Tie Rod-to-Spindle | 65-75 (88-102) |