Coil Spring: Installation

Using new spring insulator, index insulator against tip of spring and press down until it snaps into place. Install spring in control arm, making sure it is properly seated in spring pocket. See Fig 2.

Fig 1: Index Location for Rear Spring
Courtesy of FORD MOTOR CO.
Raise spring and control arm with floor jack. Position spring in pocket on underbody. Using new bolt, nut and washer, attach control arm to spindle. Bolt head should face front of vehicle.
Tighten bolt to specifications. Install tire and wheel. Remove floor jack and lower vehicle.

Fig 2: Rear Suspension Assembly (Front Wheel Drive Models)
Courtesy of FORD MOTOR CO.