LEMON Manuals: Even more car manuals for everyone
Home >> Mercury >> 1980 >> Bobcat Base, Automatic Trans >> Repair and Diagnosis >> Electrical >> Motors, Switches, Relays >> Switches, Gauges & Instrument Panels >> Testing >> Gauges >> Temperature Gauge Calibration Test

Temperature Gauge Calibration Test

  1. When gauge is suspected of being out of calibration, having a fluctuating movement or high or low readings, both gauge and IVR must be tested simultaneously. This test is done on vehicle.
  2. Disconnect lead from gauge at sender unit, connect resistor between gauge lead and ground. Turn ignition to "ON" position, with 10 ohm resistor, gauge should read within 1/2 pointer width on either side of "H" graduation. With 73 ohm resistor, gauge should read within 1/2 pointer width on either side of "C" graduation.
  3. If gauge does not perform as prescribed, replace IVR and retest. If gauge now (with new IVR) reads correctly, problem is solved. If gauge is still out of calibration it is defective and must be replaced.
scientia non olet · About LEMON Manuals