LEMON Manuals: Even more car manuals for everyone
Home >> Mercury >> 1980 >> Bobcat Base, Automatic Trans >> Repair and Diagnosis >> Electrical >> Motors, Switches, Relays >> Sun & Moon Roofs - Electric >> Adjustment >> Vertical Alignment

Vertical Alignment

  1. Remove halo moulding from sliding panel by moving shade to rear and glass panel half-open. Remove 3 strews and pull halo moulding down and sideways. To adjust front of panel, loosen forward track retaining screws. Rotate adjuster as necessary and tighten screws.
  2. To adjust rear of panel, loosen rear slide adjusting nut. Raise or lower panel to correct position and tighten adjusting nut.
scientia non olet · About LEMON Manuals