Removal & Installation: STUDEBAKER: Installation
- Attach assembly to firewall and suspend pedal bracket with capscrews and lockwashers. Connect hydraulic and vacuum lines, and stop light switch wires. Install nylon bushings in eye of pushrod and connect pushrod to brake pedal with the special eccentric shoulder bolt.
- Adjust pedal height as follows: On Synchro-mesh cars, rotate shoulder bolt until brake pedal is at same height as clutch pedal (released position). On Auto. Trans, cars, rotate shoulder bolt so there is 7/8-1" clearance between brake pedal arm and tab on suspended pedal bracket. Hold bolt head and tighten locknut securely.