Jeep (1970-73)

After wheel brake units have been disassembled for any reason, an initial adjustment MUST be made before drum installation. Initially adjust adjusting screw assembly to a point where approximately 3/8" of threads are exposed between star wheel and star wheel nut. Drive car cautiously in reverse, making 10-15 "hard" brake applications before road testing. Make sure pedal height is correct. To adjust brakes without removing drums, remove access hole cover on backing plate and using a brake adjusting tool, rotate star wheel until locked. Insert second tool (thin rod) to push adjusting lever off wheel and back off star wheel at least 15 to 20 notches (clicks).